Find your perfect job.

Back to Job Search Results

Process Technician - Injection Molding (Closed)

Date Posted: 10/14/2020

Job #1577531
Permanent
Baraboo, Wisconsin
Staff

* This company is specifically seeking candidates with military experience. *


12 Hour Shift 7am - 7pm

Set up and operation of all injection molding presses and all related equipment to produce a quality product. Diagnose problems of the process and secondary equipment along with some electrical troubleshooting. Set large molds and track water circuits.

 

Job Responsibilities

  • Perform all assigned duties in a safe manner to assure maximum protection to self and fellow employees.
  • Detect safety hazards and eliminate or correct unsafe working conditions. Report unsafe conditions immediately to shift supervisor.
  • Responsible for change over and set up of all injection molding machines and secondary equipment to make a high quality part that meets the customer specifications and guidelines of company specifications.
  • Responsible for troubleshooting the process, including machines and all related equipment, with the assistance from maintenance personnel if needed.
  • Responsible for the correct and safe setup of secondary equipment.
  • Maintain constant surveillance of quality.
  • Maintain highest housekeeping standards at all times to support 5S.
  • Work closely with shift supervisors and plant personnel to bring about continuous improvements.
  • Inform shift supervisor of problems encountered, changes to operating conditions and request assistance when needed.
  • Perform other duties as assigned by the shift supervisor or process engineer.
  • Perform overtime duties as assigned by the shift supervisor.
  • Perform other duties as assigned.

 

Required Skills
  • Basic Injection molding skills.
  • Ability to be forklift certified.
  • Ability to make independent judgments when the supervisor and the process engineer is absence.
  • Ability to add, subtract, multiply and divide.
  • Good written and oral communication skills.

Required Experience

  • HS Diploma or GED required
  • RJG Scientific Molding knowledge is a plus.

Physical Demands

  • Continuously lifting or moving material of light weight (up to 10 pounds).
  • Frequently lifting or moving average weight material (between 25# to 60#).
  • Occasionally lifting or moving heavy weight material (over 60#).
  • Ability to climb railcars, ladders and steep stairs to perform service (height).